Rare earth photoionization study by the resonant microwave cavity technique

Photoconductivity spectra of rare earth-doped insulating materials are measured using the resonant microwave cavity method. This technique is based on the detection of the cavity Q-factor changes induced by irradiation of the sample (inserted in the cavity) by a pulsed tunable laser. Results obtained with Lu₂(SiO₄)O:Ce³⁺ and BaF₂:Eu²⁺ are presented and discussed. Photoionization thresholds at 400 nm (3.1 eV) and 310 nm (4.0 eV) are measured for Lu₂(SiO₄)O:Ce³⁺ and BaF₂:Eu²⁺, respectively.     

Structure and properties of the mesophase of syndiotactic polystyrene. VIII. Solvent sorption behavior of syndiotactic polystyrene/p‐chlorotoluene mesophase membranes

A crystalline δ form of a syndiotactic polystyrene (sPS) membrane was prepared from a solution of sPS (1 wt %) and p‐chlorotoluene (p‐CT) by a solution‐casting method. The mesophase (δ empty form) of sPS was obtained by the extraction of the guest solvent from the δ form of sPS by a stepwise solvent‐extraction method. The sPS/p‐CT mesophase membrane [p‐CT (A‐M)] was used for the sorption of 1 mol % p‐CT for different times and for the sorption of different concentrations of p‐CT, chlorobenzene (CB), p‐xylene (p‐X), toluene, and chloroform for 48 h. The presence of solvents in the sPS membrane was confirmed by IR analysis. A thermal study revealed that the sorption amount of 1 mol % p‐CT increased with increasing immersion time, and the sorption amounts of different solvents increased with increasing solvent concentration. Differential scanning calorimetry results showed that the desorption peak temperature increased as the amount of the solvent increased in the clathrated sPS membrane. Wide‐angle X‐ray diffraction results showed that 2θ at 8.25° was slightly shifted toward 8°, and there was no change in the peak position at 10° for p‐CT (A‐M), which was immersed in different solvents (1 mol %); however, the intensity of 2θ at 10° was not similar for all the samples. Among the solvents used for the sorption studies at 1 mol %, p‐CT (A‐M) could sorb more p‐CT and CB than p‐X, toluene, and chloroform. The solvent sorption isotherm was the Langmuir sorption mechanism. © 2004 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 42: 3439–3446, 2004     

级联三能级原子与单模场相互作用下的腔场谱

研究了高Q腔内级联三能级原子与单模光场相互作用模型的腔场谱.结果表明,原子初态处于上能级时，随R=g2/g1的增大,真空场的拉比峰个数按2→6→4→2→4的规律变化，在R1时，所有的拉比峰都消失.在初始场较弱时,腔场谱可出现3峰、5峰或7峰.在初始场很强时,腔场谱中只有单一的经典共振峰.如果原子初态处在中能级且R=1,腔场谱为简单的对称双峰结构，与标准J-C模型的谱相似. 关键词： 级联三能级原子 单模光场 腔场谱     

切伦柯夫相互作用中分段式慢波结构与均匀慢波结构的比较研究

 分析了切伦柯夫束波相互作用中使用单段慢波结构的缺点。指出在分段式慢波结构中，漂移段及其两端的慢波结构组成一Bragg谐振腔，当漂移段长度合适时，根据渡越时间效应理论，这种结构能减小调制束中电子的速度分散，提高束波转化效率。通过粒子模拟方法，比较了均匀慢波结构与分段式慢波结构中束波相互作用的物理图像，验证了理论分析结果，并说明了后者有束密度群聚充分，束电子速度分散小，产生微波功率高、频谱质量好，最佳工作电流大，输入电功率高等优点。     

X波段六腔渡越管振荡器的高频特性研究

 从麦克斯韦方程出发，采用时域有限差分法（FDTD）和离散傅里叶变换（DFFT）相结合的方法，通过数值计算得出了六腔开放式谐振腔中前四个谐振频率和场分布，计算出的谐振频率与实验测量结果基本相同。比较了开放腔和封闭腔谐振频率，验证了TEM波吸收边界条件，并在实际编程计算中得以应用。计算结果为六腔渡越管振荡器的机理研究提供了依据。     

含色散介质的一维光子晶体微腔的透射谱

研究了含色散介质的一维光子晶体微腔的透射谱,对色散介质采用Lorentz振子模型,腔模的频率设置在光子晶体带隙中心。发现当吸收可以忽略时,色散效应将导致在腔模附近有很高的态密度,与此相应地在透射谱中出现一个较宽的透射带。当吸收存在时透射带中心的透射峰消失,但带尾的透射峰依然存在。     

Revisiting Probabilistic Teleportation Scheme for Atomic State via Cavity QED

A probabilistic teleportation scheme for atomic state via cavity QED [Phys. Rev. A 70 (2004) 054303] is revisited and accordingly some improvements are made.     

光放大器前置可调光学滤波器

介绍Ｆ－Ｐ干涉滤波器实现中心波长可调的两种机理，给出通过改变腔距来改变中心波工的滤波器的典型结构，并且给出了相应的电压驱动电路，实验表明选择合适的光放大器前置滤波器可以提高系统的灵敏度。     

利用CARS方法研究超短脉冲激光的脉冲宽度

在理论上提出了利用两光束CARS/CSRS方法测量超短脉冲激光的三阶相关函数。实验上在几种样品中测量了CARS/CSRS的时间特性,得到了泵浦光脉冲,SCDL输出光脉冲以及受激喇曼散射光脉冲的宽度。     

三维射频加速腔程序包MAFIA的开发和应用

介绍了三维射频加速器计算机辅助设计(CAD)程序包MAFIA的特点、功能及其应用。用CAD的方法实现了射频加速器特别是非轴对称带耦合腔的加速器的三维腔形设计。同时介绍了节省内存、节约机时的模型方法,使得在中小型机器上运行大程序(八万条)成为可能。文章主要对L波段的加速腔进行了数值模拟,并和实验进行了比较,结果符合较好;通过三维数值模拟及图形模拟的方法比较了各种形状谐振腔的性能;计算分析了输入耦合腔及高阶模耦合器对加速腔电磁场分布等参量的影响;提出了加耦合器后谐振频率改变的补偿方法。